U2C_RESULT U2C_PutByte( HANDLE hDevice, BYTE Data );
The U2C_PutByte() function shifts out (transmits) a single byte to I2C bus. It assumes that the bus is available and Start Condition has been generated first. This function doesn't check acknowledge from I2C slave device, so you must call the U2C_GetAck() function to check acknowledge or to use U2C_PutByteWithAck() instead ofU2C_PutByte() function. This function can be called several times to implement custom I2C-like protocol. The function does not finish I2C bus transaction after transmission, so at the end of I2C transaction U2C_Stop() function has to be called.
Handle to the U2C-12 device.
Byte value to be transmitted to the I2C bus.
Byte was successfully transmitted to the I2C bus.
U2C-12 device referenced by hDevice handle was not found.