DLN_GPIO_PIN_CONFIG Structure

The DLN_GPIO_PIN_CONFIG structure contains information about the pin configuration.

Syntax

C/C++

typedef struct
{
    uint16_t cfg;
    uint8_t eventType;	
    uint16_t eventPeriod;
} __PACKED_ATTR DLN_GPIO_PIN_CONFIG;

Structure Members

cfg

A bit field that defines the pin configuration and consists of 16 bits. Each of the bits 0-6, 8-9 corresponds to a specific parameter, that defines the pin configuration. The bits 7, 10-15 are reserved.


Bit	Value	Description	Constant
0	0	The pin is not configured as a GPIO.	DLN_GPIO_DISABLED
0	1	The pin is configured as a GPIO.	DLN_GPIO_ENABLED
1	0	The pin is an input.	DLN_GPIO_INPUT
1	1	The pin is an output.	DLN_GPIO_OUTPUT
2	0	The output value is 0.	DLN_GPIO_OUTPUT_VAL_0
2	1	The output value is 1.	DLN_GPIO_OUTPUT_VAL_1
3	0	The output is open drain.	DLN_GPIO_OPEN_DRAIN_DISABLED
3	1	The output is push-pull.	DLN_GPIO_OPEN_DRAIN_ENABLED
4	0	The pull-up resistor is not active.	DLN_GPIO_PULLUP_DISABLED
4	1	The pull-up resistor is active.	DLN_GPIO_PULLUP_ENABLED
5	0	The debounce filter is not active.	DLN_GPIO_DEBOUNCE_DISABLED
5	1	The debounce filter is active.	DLN_GPIO_DEBOUNCE_ENABLED
6	0	The pull-down resistor is not active.	DLN_GPIO_PULLDOWN_DISABLED
6	1	The pull-down resistor is active.	DLN_GPIO_PULLDOWN_ENABLED
7		Reserved.
8	0	No events are generated.	DLN_GPIO_EVENT_DISABLED
8	1	Events are generated.	DLN_GPIO_EVENT_ENABLED
9	0	Single events are generated.	DLN_GPIO_EVENT_SINGLE
9	1	Periodical events are generated.	DLN_GPIO_EVENT_PERIODIC
10		Reserved.
11		Reserved.
12		Reserved.
13		Reserved.
14		Reserved.
15		Reserved.

eventType

A type of the event. The following values are available:


Value	Constant	Description
0	DLN_GPIO_EVENT_NONE	No events are generated.
1	DLN_GPIO_EVENT_CHANGE	Events are generated when the input value changes.
2	DLN_GPIO_EVENT_LEVEL_HIGH	Events are generated when the high level (logic 1) is detected.
3	DLN_GPIO_EVENT_LEVEL_LOW	Events are generated when the low level (logic 0) is detected.
4	DLN_GPIO_EVENT_ALWAYS	The events are generated periodically with the predefined interval.

For detailed information, read Digital Input Events.

eventPeriod

An interval in milliseconds (ms) at which the events are generated. If the interval is zero, the DLN adapter generates a single event when the level change meets the specified conditions.